Moxa - WLAN AP/Bridge/Client
SKU
AWK-1131A-JP
Moxa - 802.11n Access Point, JP band, 0 to 60C
$824.68
Ready to Order
Please contact us for lead time
WLAN Interface
-
WLAN Standards
- 802.11a/b/g/n
802.11i Wireless Security
- 802.11a/b/g/n
-
Modulation Type
- DSSS
OFDM
MIMO-OFDM
- DSSS
-
Frequency Band for JP (20 MHz operating channels)
- 2.412 to 2.484 GHz (14 channels)
5.180 to 5.240 GHz (4 channels)
5.260 to 5.320 GHz (4 channels) DFS (Dynamic Frequency Selection) channel support: In AP mode, when a radar signal is detected, the device will automatically switch to another channel. However according to regulations, after switching channels, a 60-second availability check period is required before starting the service.
5.500 to 5.700 GHz (11 channels) DFS (Dynamic Frequency Selection) channel support: In AP mode, when a radar signal is detected, the device will automatically switch to another channel. However according to regulations, after switching channels, a 60-second availability check period is required before starting the service.
- 2.412 to 2.484 GHz (14 channels)
-
Wireless Security
- WEP encryption (64-bit and 128-bit)
WPA/WPA2-Enterprise (IEEE 802.1X/RADIUS, TKIP, AES)
WPA/WPA2-Personal
- WEP encryption (64-bit and 128-bit)
-
Transmission Rate
- 802.11b: 1 to 11 Mbps
802.11a/g: 6 to 54 Mbps
802.11n: 6.5 to 300 Mbps
- 802.11b: 1 to 11 Mbps
-
Transmitter Power for 802.11a
- 23±1.5 dBm @ 6 to 24 Mbps
21±1.5 dBm @ 36 Mbps
20±1.5 dBm @ 48 Mbps
18±1.5 dBm @ 54 Mbps
- 23±1.5 dBm @ 6 to 24 Mbps
-
Transmitter Power for 802.11n (5 GHz)
- 23±1.5 dBm @ MCS0/8 20 MHz
18±1.5 dBm @ MCS7/15 20 MHz
23±1.5 dBm @ MCS0/8 40 MHz
17±1.5 dBm @ MCS7/15 40 MHz
- 23±1.5 dBm @ MCS0/8 20 MHz
-
Transmitter Power for 802.11b
- 26±1.5 dBm @ 1 Mbps
26±1.5 dBm @ 2 Mbps
26±1.5 dBm @ 5.5 Mbps
25±1.5 dBm @ 11 Mbps
- 26±1.5 dBm @ 1 Mbps
-
Transmitter Power for 802.11g
- 23±1.5 dBm @ 6 to 24 Mbps
21±1.5 dBm @ 36 Mbps
19±1.5 dBm @ 48 Mbps
18±1.5 dBm @ 54 Mbps
- 23±1.5 dBm @ 6 to 24 Mbps
-
Transmitter Power for 802.11n (2.4 GHz)
- 23±1.5 dBm @ MCS0/8 20 MHz
18±1.5 dBm @ MCS7/15 20 MHz
23±1.5 dBm @ MCS0/8 40 MHz
17±1.5 dBm @ MCS7/15 40 MHz
- 23±1.5 dBm @ MCS0/8 20 MHz
-
Transmitter Power
-
US EU JP 2.4 GHz 26 dBm 18 dBm 18 dBm 5 GHz (UNII-1) 23 dBm 21 dBm 21 dBm 5 GHz (UNII-2) 23 dBm 21 dBm 21 dBm 5 GHz (UNII-2e) 23 dBm 23 dBm 23 dBm 5 GHz (UNII-3) 23 dBm – – Note: Based on regional regulations, the maximum transmission power allowed on the UNII bands is restricted in the firmware, as indicated above.
-
-
Receiver Sensitivity for 802.11a (measured at 5.680 GHz)
- Typ. -90 @ 6 Mbps
Typ. -88 @ 9 Mbps
Typ. -88 @ 12 Mbps
Typ. -85 @ 18 Mbps
Typ. -81 @ 24 Mbps
Typ. -78 @ 36 Mbps
Typ. -74 @ 48 Mbps
Typ. -72 @ 54 Mbps
Note: Due to a limitation in the receiver sensitivity performance for channels 153 and 161, it is recommended to avoid using these channels in your critical applications.
- Typ. -90 @ 6 Mbps
-
Receiver Sensitivity for 802.11n (5 GHz; measured at 5.680 GHz)
- Typ. -69 dBm @ MCS7 20 MHz
Typ. -71 dBm @ MCS15 20 MHz
Typ. -63 dBm @ MCS7 40 MHz
Typ. -68 dBm @ MCS15 40 MHz
Note: Due to a limitation in the receiver sensitivity performance for channels 153 and 161, it is recommended to avoid using these channels in your critical applications.
- Typ. -69 dBm @ MCS7 20 MHz
-
Receiver Sensitivity for 802.11b (measured at 2.437 GHz)
- Typ. -93 dBm @ 1 Mbps
Typ. -93 dBm @ 2 Mbps
Typ. -93 dBm @ 5.5 Mbps
Typ. -88 dBm @ 11 Mbps
- Typ. -93 dBm @ 1 Mbps
-
Receiver Sensitivity for 802.11g (measured at 2.437 GHz)
- Typ. -88 dBm @ 6 Mbps
Typ. -86 dBm @ 9 Mbps
Typ. -85 dBm @ 12 Mbps
Typ. -85 dBm @ 18 Mbps
Typ. -85 dBm @ 24 Mbps
Typ. -82 dBm @ 36 Mbps
Typ. -78 dBm @ 48 Mbps
Typ. -74 dBm @ 54 Mbps
- Typ. -88 dBm @ 6 Mbps
-
Receiver Sensitivity for 802.11n (2.4 GHz; measured at 2.437 GHz)
- Typ. -70 dBm @ MCS7 20 MHz
Typ. -69 dBm @ MCS15 20 MHz
Typ. -67 dBm @ MCS7 40 MHz
Typ. -67 dBm @ MCS15 40 MHz
- Typ. -70 dBm @ MCS7 20 MHz
-
WLAN Operation Mode
- Access point, Client, Sniffer
-
Antenna
- External, 2/2 dBi, Omni-directional
-
Antenna Connectors
- 2 RP-SMA female
Ethernet Interface
-
Standards
- IEEE 802.3 for 10BaseT
IEEE 802.3u for 100BaseT(X)
IEEE 802.3ab for 1000BaseT(X)
IEEE 802.1X for authentication
- IEEE 802.3 for 10BaseT
-
10/100/1000BaseT(X) Ports (RJ45 connector)
- 1
Ethernet Software Features
-
Management
- DHCP Server/Client, DNS, HTTP, IPv4, LLDP, Proxy ARP, SMTP, SNMPv1/v2c/v3, Syslog, TCP/IP, Telnet, UDP, VLAN, Wireless Search Utility, MXview, MXview Wireless, MXconfig
-
Security
- HTTPS/SSL, RADIUS, SSH
-
Time Management
- SNTP Client
Firewall
-
Filter
- ICMP, MAC address, IP protocol, Port-based
Serial Interface
-
Console Port
- RS-232, 8-pin RJ45
LED Interface
-
LED Indicators
- PWR, FAULT, STATE, SIGNAL, WLAN, LAN
Input/Output Interface
-
Buttons
- Reset button
Physical Characteristics
-
Housing
- Metal
-
IP Rating
- IP30
-
Dimensions
- 58 x 115 x 70 mm (2.29 x 4.53 x 2.76 in)
-
Weight
- 307 g (0.68 lb)
-
Installation
- DIN-rail mounting, Wall mounting (with optional kit)
Power Parameters
-
Input Current
- 0.56 A @ 12 VDC, 0.14 A @ 48 VDC
-
Input Voltage
- 12 to 48 VDC
-
Power Connector
- 1 removable 4-contact terminal block(s)
-
Power Consumption
- 6.96 W (max.)
-
Reverse Polarity Protection
- Supported
Environmental Limits
-
Operating Temperature
- 0 to 60°C (32 to 140°F)
-
Storage Temperature (package included)
- -40 to 85°C (-40 to 185°F)
-
Ambient Relative Humidity
- 5 to 95% (non-condensing)
Standards and Certifications
-
EMC
- EN 55032/24
-
EMI
- CISPR 32, FCC Part 15B Class A
-
EMS
- IEC 61000-4-2 ESD: Contact: 4 kV; Air: 8 kV
IEC 61000-4-3 RS: 80 MHz to 1 GHz: 10 V/m
IEC 61000-4-4 EFT: Power: 2 kV; Signal: 1 kV
IEC 61000-4-5 Surge: Power: 2 kV; Signal: 1 kV
IEC 61000-4-6 CS: 3 V
IEC 61000-4-8 PFMF
- IEC 61000-4-2 ESD: Contact: 4 kV; Air: 8 kV
-
Radio
- EN 300 328, EN 301 489-1/17, EN 301 893, FCC ID SLE-WAPN008, MIC, NCC, RCM, SRRC, WPC, KC, ANATEL
-
Safety
- EN 60950-1, UL 60950-1
-
Vibration
- IEC 60068-2-6
MTBF
-
Time
- 749,476 hrs
-
Standards
- Telcordia SR332
Warranty
-
Warranty Period
- 5 years
-
Details